[BFix] 5.8 1995 F150 MAF compatible with the Mustang HO?

[Joe Lougee]

Dan, check the wiring on the F150 MAF, I was under the impression that 
all the OBD II vehicles used a 5 wire MAF, not a 4 wire.  Maybe the '95 
CA is different.

Actually, as I think about it, I thought the '95 CA 5.8 was a MAF OBD I 
setup?????
Joe


Dan wrote:
> I am working on a 5.8 SEFI install.   The motor is a stock '95 California
> F150 5.8L which ran an EEC-V OBD computer and 19lb injectors.  I am
> converting to 89 - 93 HO stuff.
>
> I have purchased a GT40 lower (Scott at ABCO) and a Cobra upper.  Jim Smith
> donated the IAB.  I have an A9L computer.
>
> The F150 MAF has an oval connector similar, but not exactly the same as the
> Mustang MAF.  
>
> The only difference with the connector on the MAF is that the guide tab on
> the F150 MAF is on the narrow end of the connector and the Mustang MAF
> connector (Ryan's harness) has the guide tab on the broad side of the oval
> connector.  
>
> Do you all think the F150 MAF is compatible?  If I shaved off the guide tab,
> would it work correctly?
>
> Dan
>
> _______________________________________________
> bfix mailing list
> bfix at broncofix.com
> http://broncofix.com/mailman/listinfo/bfix
>
>