[BFix] centech help

[Formerjughead at aol.com]

It sounds like you emergency flasher switch is either bad or not grounded.  
Take it out and test for continuity, or lack of , in the off position.
 
 
In any case you have power going straight to the emergency flasher module  
and you need to determine if it is traveling through the switch or going  
straight to the module and by passing the switch

 
Do they stop flashing when you activate the turn signals, honk the horn,  
apply the brakes or turn on the head lights? 
 
What about if you turn on the heater, wipers or radio?
 
Look at the harness to column connector and make sure everything is  properly 
connected, un do the turn signal connection and see if that makes a  
difference and then check the flasher connection.........they may be  reversed.
 
 
Brad
 
 
 
In a message dated 4/25/2008 5:43:30 P.M. Pacific Daylight Time,  
bfranklinisg at earthlink.net writes:

I installed a centech harness over the last few months and I am going to  try 
to work on it some tonight maybe. Anyway, my problem is that my blinkers  
flash constantly no matter if the hazard switch is on or off. I also installed  a 
new ididit tilt column at the same time so it's compatible with the harness  
and is brand spankin new.
 
Anybody care to direct me in a good place to start lookin?
 
thanks Ben
 
 
_bfranklinisg at earthlink.net_ (mailto:bfranklinisg at earthlink.net) 
EarthLink Revolves Around You.
 


_______________________________________________
bfix mailing  list
bfix at broncofix.com
http://broncofix.com/mailman/listinfo/bfix





**************Need a new ride? Check out the largest site for U.S. used car 
listings at AOL Autos.      
(http://autos.aol.com/used?NCID=aolcmp00300000002851)
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.broncofix.com/pipermail/bfix/attachments/20080425/d4fa41f8/attachment.html