[BFix] gear setup

[Laughner Bruce]

it'll be right when I am done......but its probably take a few more tries
: ) I've set them up b4 without issue and right now I believe I have it
figured out. I ain't never going to learn nutin' if I pay some one else to
do it ( words of wisdom from my grandfather ).


Thanks,
Bruce

----- Original Message -----
From: "Allen and Pam Wells" <alpashco at cox.net>
To: "Laughner Bruce" <legacy1 at windstream.net>
Sent: Saturday, May 03, 2008 12:14 PM
Subject: RE: [BFix] gear setup


> I hate to say this as I know it just means more $, but that is why I let a
> shop do my gears.  Pinion position is absolutely critical!  Plus knowing
the
> exact amount of shims is probably as much measurement aas it is
experience.
> I burned up a rear output on a Dana 20 because I had the "how hard could
it
> be" attitude.  Cost me $110 to get it built right, but it is right now!
>
> Allen Wells
> 1970 - 5.0 SEFI, NV3550, 5.5" total lift,
> 44/BB9", 4whl disc, 4.56's, ETC.
> ----------------------------
> 1966 Box Of Bronco
> ----------------------------
> Las Vegas, Nevada
>
>
> -----Original Message-----
> From: bfix-bounces at broncofix.com [mailto:bfix-bounces at broncofix.com]On
> Behalf Of Laughner Bruce
> Sent: Saturday, May 03, 2008 8:36 AM
> To: bfix
> Subject: [BFix] gear setup
>
>
> Ok everybody, I just set up a new ring and pinion in the front of the
boy's
> '76. Everything looked great until I put the new seals in it. Now there is
> all kinds of drag when you turn the pinion. I am on my way back out to see
> what I can find but I was hoping somebody may have an answer to my
dilemna,
> my frustration level has spiked !
>
> Thanks,
> Bruce G. Laughner
> '77 Bronco
>
> _______________________________________________
> bfix mailing list
> bfix at broncofix.com
> http://broncofix.com/mailman/listinfo/bfix
>
>
>
> --
> No virus found in this incoming message.
> Checked by AVG.
> Version: 7.5.524 / Virus Database: 269.23.8/1412 - Release Date: 5/2/2008
4:34 PM
>
>